Simultaneous Serial Data Transmission And Reception - Renesas H8 Series Hardware Manual
16-bit single-chip microcomputer
Hide thumbs
Also See for H8 Series:
- Hardware manual (697 pages) ,
- User manual (272 pages) ,
- User manual (408 pages)
Table of Contents
Advertisement
Section 14 Serial Communication Interface 3 (SCI3)
14.5.5
Simultaneous Serial Data Transmission and Reception
Figure 14.15 shows a sample flowchart for simultaneous serial transmit and receive operations.
The following procedure should be used for simultaneous serial data transmit and receive
operations. To switch from transmit mode to simultaneous transmit and receive mode, after
checking that SCI3 has finished transmission and the TDRE and TEND flags are set to 1, clear TE
to 0. Then simultaneously set TE and RE to 1 with a single instruction. To switch from receive
mode to simultaneous transmit and receive mode, after checking that SCI3 has finished reception,
clear RE to 0. Then after checking that the RDRF and receive error flags (OER, FER, and PER)
are cleared to 0, simultaneously set TE and RE to 1 with a single instruction.
Rev. 3.00 Sep. 14, 2006 Page 225 of 408
REJ09B0105-0300
Advertisement
Table of Contents
