Engine Id Code Locations; Four-Cylinder Engine Mounting - Jeep J-10 Series 1982 Technical & Service Manual

1B-4 ENGINES
OIL
PAN
GASKET
OIL
PAN
WIRE
HARNESS
PROTECTOR
©
r -
OIL PUMP
DRIVESHAFT
OIL PUMP
PICKUP
TUBE AND
STRAINER
BOLTS
OIL PAN
REINFORCEMENTS
90792C
R|. 1B-3 Fw-^twfvEflglM/UtifflcIy^Dr^aBdPiap
ID CODE
GEORGIA AND
TENNESSEE ID
90793
Fl|. 1B-4 Eigloi ID Code Lcutloos
(12) Lower vehicle.
(13) Support transmission with floor jack.
(14) Identify, tag and remove vacuum hoses from
canister and carburetor.
(15) Remove bowl vent hose from carburetor. Dis
connect mixture control solenoid wire connector from
carburetor, if equipped.
(16) Remove wires from alternator.
(17) Disconnect throttle cable from bracket and from
carburetor.
(18) Disconnect choke and solenoid wires at
carburetor.
RIGHT FRONT
SUPPORT MOUNTING
BRACKET
RIGHT FRONT
SUPPORT CUSHION
LEFT FRONT
SUPPORT
CUSHION
LEFT FRONT
SUPPORT MOUNTING
BRACKET
HEAT
SHIELD
SUPPORT BRACKET
INSULATOR
RIGHT FRONT
FRAME SUPPORT
MOUNTING BRACKET
LEFT FRONT
FRAME SUPPORT
MOUNTING BRACKET
81044A
Rg. 1B-5 FoHr-Cyllnder Eagtee IJoMtiii
(19) Disconnect engine coolant temperature sender
wire connector.
WARNING: Do not loosen radiatordraincockwith sys
tem hot and under pressure becauseserious burnsfrom
coolant can occur.
(20) Drain radiator and remove lower radiator hose.
(21) Remove heater hoses from heater core inlet and
outlet tubes.
NOTE: DO NOT WASTE reusable coolant If solution
is clean, drain coolant into a clean containerfor reuse.
NOTE: It may be necessary to attach a flexible hose to
draincock to route coolant to container.
(22) Remove fan shroud bolts. Remove upper radi
ator hose, radiator and shroud.
(23) Remove power steering hoses at pump.
CAUTION: Manual transmission may have to be
raised to provide a smooth engine/transmission
separation.
(24) Attach engine hoisting sling and remove engine.
Installation
(1) Lower engine into engine compartment. Ensure
that transmission shaft mates correctly with clutch disc
and pilot bushing.
(2) Connect power steering hoses.
(3) Connect and secure heater hoses to heater core
with clamps.
(4) Connect following wire connectors:
(a) Coolant Temperature sender
(b) Oil pressure sender