Valves And Actuating Compomnents - Jeep J-10 Series 1982 Technical & Service Manual

(c) Choke and solenoid
(d) Mixture control solenoid, if equipped.
(5) Connect vacuum hoses to canister and carbu
retor. Ensure hoses are connected correctly according to
identifying tags that were attached prior to removal.
(6) Connect bowl vent hose to carburetor.
(7) Connect alternator wires.
(8) Attach throttle cable to carburetor. Secure cable
in position with bracket.
(9) Position fan shroud over fan. Install radiator
and connect upper and lower radiator hoses. Attach
shroud to radiator. Fill system with coolant.
NOTE: Refer to Chapter lC—Cooling Systems for ad
ditional information.
(10) Raise vehicle.
(11) Install flywheel inspection plate and hydraulic
clutch slave cylinder (manual transmission only).
Tighten bolts with 225 inch-pounds (25 N«m) torque.
(12) Install engine mounting nuts. Tighten with 34
foot-pounds (46 N*m) torque.
(13) Install starter motor. Tighten bolts with 27 foot
pounds (37 N«m) torque and bracket nut with 40 inch-
pounds (4.5 N*m) torque.
(14) Connect battery cable and solenoid wire to
starter motor solenoid.
(15) Connect distributor wire connector.
(16) Connect exhaust pipe to exhaust manifold.
Tighten securing nuts with 35 foot-pounds (50 N»m)
torque. Connect oxygen sensor wire connector, if
equipped.
(19) Connect battery negative cable and body ground
wire.
(20) Install air cleaner.
WARNING: Use extreme caution when engine 13 oper
ating. Do not stand in direct line with fan. Do not put
hands near pulleys, belts or fan. Do not wear loose
clothing.
(21) Start engine and inspect for leaks. Refill fluids
as necessary.
VALVES AND ACTUATING COMPONENTS
Giniril
Motion is transmitted from the camshaft through the
hydraulic tappet and push rod to the rocker arm. Each
rocker arm moves on its pivot ball and transmits the
camshaft motion to the valve. The rocker arm and pivot
ball are retained by a capscrew (fig. 1B-6).
ENGINES 1B-5
CAPSCREW
PIVOT BALL
ROCKER
\ H ARM
I V T /
PUSH ROD
EXHAUST SIDE OF
CYLINDER HEAD
INTAKE SIDE OF
CYLINDER HEAD
CAST
COMBUSTION
CHAMBERS
TAPPET
FRONT
90795
CAP
SCREW
EXHAUST
VALVE
INTAKE
VALVE
81064A
81064B
Fig. 1B-6 Valves and Actuating Components