Mazda RX-8 Manual page 794

Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
1
Has FREEZE FRAME DATA been
•
recorded?
VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
Verify related Service Bulletins and/or
•
2
on-line repair information availability.
Is any related repair information
•
available?
VERIFY RELATED PENDING CODE OR
STORED DTC
Turn the ignition switch off, then to the
•
3
ON position (Engine off).
Verify the related PENDING CODE or
•
stored DTCs.
Are other DTCs present?
•
INSPECT DRIVE-BY-WIRE CONTROL
SYSTEM OPERATION
Perform the "Drive-by-wire Control
•
System Inspection".
4
(See Drive-by-wire Control System
Inspection .)
Is there any malfunction?
•
INSPECT A/C MAGNETIC CLUTCH
OPERATION
5
NOTE:
ACTION
Yes Go to the next step.
Record the FREEZE FRAME DATA on the
No
repair order, then go to the next step.
Perform repair or diagnosis according to the
available repair information.
Yes
If the vehicle is not repaired, go to the
•
next step.
No Go to the next step.
Go to the applicable DTC inspection.
Yes
(See DTC TABLE .)
No Go to the next step.
Repair or replace the malfunctioning part
according to the inspection results.
Yes
Then go to Step 15.
No Go to the next step.
Go to the "NO.24 A/C IS ALWAYS ON OR
A/C COMPRESSOR RUNS
CONTINUOUSLY.".
Yes
(See NO.24 A/C IS ALWAYS ON OR A/C
COMPRESSOR RUNS CONTINUOUSLY .)
(w) Engine Diagnostics & Control
Page 231