Remove; Transmission Assembly; Install - Taylor-Dunn E0-455-24 Service And Replacement Parts Manual

E-455

REMOVE

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.

TRANSMISSION ASSEMBLY

Remove
1: Disconnect the motor cables.
2: Disconnect the park brake cable from the brake arm and
the swing arm mount.
3: Disconnect the brake hose from the t-fitting on the swing
arm (front side between suspension bumpers).
4: Remove the nuts from the rear suspension bumper bolts.
5: Raise the rear of the vehicle and support with jack stands.
Note: Do not raise the vehicle so high to where the rear wheels
come off of the ground.
6: Remove the swing arm pivot bolts and roll the transmission
assembly out from under the vehicle.

Install

1: Install the transmission assembly in reverse order of
removal.
• Bleed the brake system. Refer to section
• Adjust the park brake. Refer to section
2: Test drive
ME-455-04
for information regarding bleeding the brakes.
Brake Service
for information regarding adjusting the park brake.
Brake Service
Transaxle - GT
Page 35