Front Axle Removal And Installation; Removal - Taylor-Dunn SC-001-59 Operation, T Roubleshooting And Replacement Parts Manual

FRONT AXLE REMOVAL AND INSTALLATION

Removal

1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and
support the vehicle. Failure to use lifting
and support devices of rated load capacity
may result in severe bodily injury.
6. Remove the front axle nut.
7. Slowly raise the front of the vehicle until the axle
can slide freely out of the fork. The front wheel(s)
should still be resting on the ground.
8. Remove the front axle from the fork and support
the vehicle with jack stands.
Maintenance, Service, and Repair
Installation
1. Raise the front of the vehicle so that the hole for
the axle is the same height as the front wheel hub.
2. Assemble the bearing spacers into the front wheel
hub and place the front wheel(s) into the fork.
3. Insert the axle into the front fork.
4. Install the axle nut(s). Refer to
Wheel Bearings
regarding tightening the front axle.
NOTE: If your vehicle is equipped with two axle nuts,
the nuts should be tightened equally so that the
same number of axle threads are visible on both
ends.
5. Lower the vehicle.
6. Reconnect the main positive and negative cables
at the batteries.
7. Remove the blocks from behind the wheels.
8. Release the park brake and test drive the vehicle.
Axle
Bearing
Typical fork illustrated.
Your fork may be different.
Adjust Front
section for information
Fork (single)
Spacer
Seal
Race
Front Axle
Page 3