UMN:CLI
10.2.4.4
10.2.4.5
338
To delete a configured interface cost for OSPF, use the following command.
Command
no ip ospf cost
no ip ospf A.B.C.D cost
Blocking Transmission of Route Information Database
OSPF routing communicates through the LAS. Each routing information is saved internal
router as a datebase, but user can configure the specific interface to block the transmis-
sion of routing information saved in database to other router.
To block the transmission of routing information to other router, use the following com-
mand.
Command
ip ospf database-filter all out
ip ospf A.B.C.D database-filter
all out
To release a blocked interface, use the following command.
Command
no ip ospf database-filter
no ip ospf A.B.C.D database-
filter
Routing Protocol Interval
Routers on OSPF network exchange various packets, about that packet transmission,
time interval can be configured in several ways
The following lists are sort of time interval which can be configured by user:
•
Hello Interval
OSPF router sends Hello packet to notify existence of itself. Hello interval is that
packet transmission interval.
•
Retransmit Interval
When router transmits LSA, it is waiting for approval information come from receiver.
In this time, if there is no answer from receiver for configured time, the router trans-
mits LSA again. Retransmit-interval is configuration of the time interval between
transmission and retransmission.
•
Dead Interval
If there is no hello packet for the configured time. The router perceives other router is
stopped working. Dead interval is configuration of the time interval which perceives
other router is stopped operating.
•
Transmit Delay
When a router transmits LSA, the traffic can be delayed by status of communications.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Interface
Deletes a configured an interface cost for OSPF.
Mode
Blocks the transmission of routing information to other
Interface
router.
Mode
Interface
Releases a blocked interface.
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619