Port Description - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
5.2.6
A50010-Y3-C150-2-7619
To configure flow control of the Ethernet port, use the following command.
Command
port flow-control PORTS { on |
off }
The following is an example of configuring flow control to port 25.
SWITCH(bridge)# show port 25
------------------------------------------------------------------------
NO TYPE PVID
------------------------------------------------------------------------
25 Ethernet
SWITCH(bridge)# port flow-control 25 on
SWITCH(bridge)# show port 25
-------------------------------------------------------------------
NO TYPE PVID
-------------------------------------------------------------------
25: Ethernet
SWITCH(bridge)#

Port Description

To specify a description of an Ethernet port, use the following command.
Command
port description PORTS
DESCRIPTION
no port description PORTS
To view description of port, use the following command.
Command
show port description PORTS
The following is an example of making description of port 1 and viewing it.
SWITCH(bridge)# port description 1 test1
SWITCH(bridge)# show port description 1
------------------------------------------------------------
NO TYPE
(ADM/OPR)
------------------------------------------------------------
1 Unknown
SWITCH(bridge)#
Mode
Configures flow control for a specified port, enter the
Bridge
port number. (default: off)
STATUS MODE
(ADMIN/OPER)
1 Up/Down Auto/Half/0
STATUS MODE
(ADMIN/OPER)
1 Up/Down Auto/Half/0
Mode
Specifies a description of an Ethernet port.
Bridge
Deletes description of specified port.
Mode
Enable
Global
Shows description of one port or more.
Bridge
Interface
STATE LINK DESCRIPTION
Up/Down 0HDX test1
Description
FLOWCTRL INSTALLED
Off Y
FLOWCTRL INSTALLED
On Y
Description
Description
UMN:CLI
77