Siemens S223 User Manual page 334

UMN:CLI
i
!
334
Step1
Open Router Configuration mode from Global Configuration mode.
Command
router ospf [<1-65535>]
no router ospf [<1-65535>]
In case that more than 2 OSPF processes are operated, a process number should be as-
signed. Normally, there is one OSPF which is operating in one router.
If OSPF routing protocol is disabled, all related configuration will be lost.
Step2
Configure a network ID of OSPF. Network ID decides IP v4 address of this network.
Command
router-id A.B.C.D
no router-id A.B.C.D
In case if using router-id command to apply new router ID on OSPF process, OSPF
process must be restarted to apply. Use the clear ip ospf process command to restart
OSPF process.
If there is changing router ID while OSPF process is operating, configuration must be
processed from the first. In this case, the hiD 6615 S323 can change only router ID with-
out changing related configurations.
Command
ospf router-id A.B.C.D
no ospf router-id A.B.C.D
To transfer above configuration to other routers, Use the clear ip ospf process com-
mand to restart OSPF process.
To display configured router-id, use the following command.
Command
show router-id
SURPASS hiD 6615 S223/S323 R1.5
Mode
Opens Router Configuration mode with enabling OSPF.
Global
Disables OSPF routing protocol.
Mode
Assigns a router ID with enabling OSPF.
Router
Deletes a configured router ID.
Mode
Changes only a router ID without changing related
configurations.
Router
Deletes a changed router ID.
Mode
Enable
Global Displays configured router ID
Bridge
User Manual
Description
Description
Description
Description
A50010-Y3-C150-2-7619