Displaying Configuration - Siemens S223 User Manual

UMN:CLI
8.3.5.9
i i
i
i
216
To delete the edge port mode, use the following command.
Command
no stp edge-port PORTS

Displaying Configuration

To display the configuration after configuring STP, RSTP, and MSTP, use the following
command.
Command
show stp
show stp mst
show stp mst MSTID-RANGE
show stp mst MSTID-RANGE { all
| PORTS} [ detail ]
In case STP or RSTP is configured in the SURPASS hiD 6615 S223/S323, you should
configure MSTID-RANGE as 0.
To display a configured MSTP of the switch, use the following command.
Command
show stp mst config-id { current |
pending }
For example, after the user configures configuration ID, if you apply it to the switch with
stp mst config-id commit command, you can check configuration ID with the show stp
mst config-id current command.
However, if the user did not use the stp mst config-id commit command in order to ap-
ply to the switch after configuration, the configuration could be checked with the show
stp mst config-id pending command.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Deletes port edge mode:
Bridge
PORTS: select the port number.
Mode
Shows the configuration of STP/RSTP/MSTP.
Shows the configuration when it is configured as
MSTP.
Shows the configuration of specific Instance, enter the
Enable
instance number.
Global
Shows the configuration of the specific Instance for the
Bridge
ports:
MSTID_RANGE: select the MST instance number.
all: select all ports.
PORTS: select port number.
detail: show detail information (as option).
Mode
Shows the MSTP configuration identifier:
Enable
current: shows the current configuration as it is used to
Global
run MST.
Bridge
pending: shows the edited configuration.
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619