Applying Rule; Modifying And Deleting Rule - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
7.6.2.5
i
7.6.2.6
A50010-Y3-C150-2-7619
To delete a specified rule action (no-match), use the following command.
Command
no no-match deny
no no-match redirect
no no-match mirror
no no-match dscp
no no-match cos
no no-match ip-prec
no no-match copy-to-cpu

Applying Rule

After configuring rule using the above commands, apply it to the system with the following
command. If you do not apply the rule to the system, all specified rules will be lost.
To save and apply a rule, use the following command.
Command
apply
1. The switch performs a detailed plausibility check and rejects the rule if the
configuration is incomplete, contains bad or unsupported values or conflicts to other
rules. In this case, the switch informs about the reason and the operator may correct
the values
2. The switch may reject a rule with the message "% Already exist rule" allthough the
name will not be listed by command, show rule. Unfortunately, the entered name in
this case interferes with the name of an internally managed rule.
Remedy: Select another name for the rule (e.g. add a prefix).
3. All previously entered values remain valid after successful (or unsuccessful)
execution of command, apply. That is, if several rules being different only in one
value should be created, then only the one changed value needs to be entered again.

Modifying and Deleting Rule

To modify a rule, use the following command.
Command
rule NAME modify
To delete a rule, use the following command.
Command
no rule [NAME]
Mode
Rule Deletes a specified rule action.
Mode
Rule Applies a rule to the system.
Mode
Global Modifies a rule, enter a rule name.
Mode
Global Deletes a rule, enter a rule name optionally.
UMN:CLI
Description
Description
Description
Description
145