Siemens S223 User Manual page 162

UMN:CLI
i
162
To remove registered dynamic MAC addresses from the MAC table, use the following
command.
Command
clear mac
clear mac NAME
clear mac NAME PORT
clear mac NAME PORT
MACADDR
To remove static MAC addresses manually registered by user from the MAC table, use
the following command.
Command
no mac
no mac NAME
no mac NAME PORT
no mac NAME PORT MACADDR
To display a MAC table in the switch, use the following command.
Command
show mac NAME [PORT]
There are more than a thousand of MAC addresses in MAC table. And it is difficult to find
information you need at one sight. So, the system shows certain amount of addresses
displaying –more– on standby status. Press any key to search more. After you find the in-
formation, you can go back to the system prompt without displaying the other table by
pressing <q>.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Clears dynamic MAC addresses.
Clears dynamic MAC addresses.
Clears dynamic MAC addresses.
Enable
NAME: enter the bridge name.
Global
PORT: enter the port number.
Bridge
Clears dynamic MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.
Mode
Deletes static MAC addresses.
Deletes static MAC addresses, enter the bridge name.
Deletes static MAC addresses.
NAME: enter the bridge name.
Bridge
PORT: enter the port number.
Deletes a specified static MAC address.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.
Mode
Shows switch MAC address, selection by port number
Enable
(subscriber port only):
Global
NAME: enter the bridge name
Bridge
PORT: select the port number.
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619