Candidate Rp Message With Cisco Bsr; Excluding Genid Option - Siemens S223 User Manual

UMN:CLI
i
9.3.8.2
9.3.8.3
314
When the Register message is transmitted, the range of Checksum in header conforms to
header part as RFC standard, but whole packet is included in the range of checksum in
case of Cisco router. For compatibility with Cisco router, you should configure the range
of Checksum of Register message as whole packet.
To configure the range of Checksum of Register message as whole packet for compatibil-
ity with Cisco router, use the following command.
Command
ip pim cisco-register-checksum
ip pim cisco-register-checksum
group-list {<1-99> | <1300-1999>
| ACCESS-LIST}
To delete a configured Cisco-compatible checksum option, use the following command.
Command
no ip pim cisco-register-
checksum
This command is disabled by default. And Register Checksum is calculated only over the
header by default.

Candidate RP Message with Cisco BSR

Cisco's BSR code does not conform to the latest BSR draft, it does not accept candidate
RPs with a group prefix number of zero. To make the hiD 6615 S323 candidate RP work
with a Cisco BSR, use the following command. This command is used to inter-operate
with older Cisco IOS versions.
Command
ip pim crp-cisco-prefix
no ip pim crp-cisco-prefix

Excluding GenID Option

To exclude the GenID option from Hello packets on particular interface for inter-operation
with older Cisco IOS versions, use the following command
Command
ip pim exclude-genid
no ip pim exclude-genid
SURPASS hiD 6615 S223/S323 R1.5
Mode
Configures the option to calculate the Register check-
sum over the whole packet.
Configures the option to calculate the Register check-
sum over the whole packet on multicast group speci-
Global
fied by the access list.
1-99: simple access-list
1300-1999: simple access list (extended range)
ACCESS-LIST: IP named standard access list
Mode
Global Deletes a configured value.
Mode
Configure the Candidate RP-Message to work with
Cisco BSR
Global
Return to the default setting
Mode
Excludes the GenID from hello packets.
Interface
Returns to the default setting.
User Manual
Description
Description
Description
Description
A50010-Y3-C150-2-7619