UMN:CLI
7.2.2
i
7.2.3
7.2.4
120
Local OAM Mode
To configure Local OAM, use the following command.
Command
{ active
oam
local
mode
passive } PORTS
Both request and loopback are possible for local OAM active. However, request or loop-
back is impossible for local OAM passive.
OAM Unidirection
When RX is impossible in local OAM, it is possible to send the information by using TX.
To enable/disable the function, use the following command.
Command
oam local unidirection enable
PORTS
oam local unidirection disable
PORTS
Remote OAM
To enable/disable remote OAM, use the following command.
Command
oam remote oam admin <1-2>
enable PORTS
oam remote oam admin <1-2>
disable PORTS
To configure the mode of remote OAM, use the following command.
Command
oam remote oam mode <1-2>
{ active | passive } PORTS
Mode
|
Bridge
Configures the mode of local OAM.
Mode
Sends the information by using TX.
Bridge
Disables to transmit the information by using TX.
Mode
Enables remote OAM.
Bridge
Disables remote OAM.
Mode
Bridge
Configures the mode of remote OAM.
SURPASS hiD 6615 S223/S323 R1.5
Description
Description
Description
Description
A50010-Y3-C150-2-7619
User Manual