Disabling Stacking; Displaying Stacking Status; Accessing To Slave Switch From Master Switch; Sample Configuration - Siemens S223 User Manual

UMN:CLI
8.10.3
8.10.4
8.10.5
8.10.6
272

Disabling Stacking

To disable stacking, use the following command.
Command
no stack

Displaying Stacking Status

Command
show stack

Accessing to Slave Switch from Master Switch

After configuring all stacking configurations, it is possible to configure and mange by ac-
cessing to Slave switch from Master switch.
To access to Slave switch from Mater switch, use the following command in Bridge con-
figuration mode.
Command
rcommand NODE
NODE means node ID from configuring stacking in Slave switch. If you input the above
command in Mater switch, Telnet connected to Slave switch is displayed and it is possible
to configure Slave switch using DSH command. If you use the exit command in Telnet,
the connection to Slave switch is down.

Sample Configuration

[Sample Configuration 1] Configuring Stacking
The following is a stacking configuration by designating SWITCH A as a master and
SWITCH B as a slave.
Switch A
Master Switch
Switch B
Slave Switch
Step 1
Assign IP address in Interface configuration mode of Switch and enable interface using
"no shutdown" command. In order to enter into Interface configuration mode, you should
SURPASS hiD 6615 S223/S323 R1.5
Mode
Global Disables the stacking function
Mode
Enable
Shows a configuration of stacking
Global
Mode
Accesses to a slave switch.
Global
NODE: node number
Manage with the same
IP address
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619