Table of Contents
Advertisement
User Manual
SURPASS hiD 6615 S223/S323 R1.5
8.4.1.4
A50010-Y3-C150-2-7619
<Layer 3 SWITCH1: IP address - 10.0.0.1/24>
SWTICH1(config)# router vrrp default 1
SWITCH1(config-router)# associate 10.0.0.5
SWITCH1(config-router)# exit
SWITCH1(config)# show vrrp
default - virtual router 1
----------------------------------------------
state
virtual mac address
advertisement interval
preemption
priority
master down interval
[1] associate address : 10.0.0.5
<Layer 3 SWITCH 2: IP Address - 10.0.0.2/24>
SWTICH2(config)# router vrrp default 1
SWITCH2(config-router)# associate 10.0.0.5
SWITCH2(config-router)# exit
SWITCH2(config)# show vrrp
default - virtual router 1
----------------------------------------------
state
virtual mac address
advertisement interval
preemption
priority
master down interval
[1] associate address : 10.0.0.5
VRRP Track Function
When the link connected to Master Router of VRRP is off as below, if link of Master
Router is not recognized, the users on the interface are not able to communicate because
the interface is not able to access to Master Router.
In the condition that Link to VRRP's master router is down as the figure shown below, or
the link of Master Router cannot be recognized, the communication would be impossible.
For the hiD 6615 S323, you can configure Master Router to be changed by giving lower
Priority to Master Router when the link of Mater Router is disconnected. This function is
VRRP Track.
master
00:00:5E:00:01:01
1 sec
enabled
100
3.624 sec
backup
00:00:5E:00:01:01
1 sec
enabled
100
3.620 sec
In case of same priorities,
SWITCH 1 with lower IP ad-
dress is configured as Master.
UMN:CLI
231
Hide quick links:
Advertisement
Table of Contents
