Enabling Interface; Disabling Interface - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
4.3.1
4.3.2
A50010-Y3-C150-2-7619
place with TCP/IP through SNMP or telnet, it requires IP address.
You can enable interface to communicate with switch interface on network and assign IP
address as the following:
•

Enabling Interface

Disabling Interface

•
Assigning IP Address to Network Interface
•
Static Route and Default Gateway
•
Displaying Forwarding Information Base(FIB) Table
•
Forwarding Information Base(FIB) Retain
•
Displaying Interface
•
Sample Configuration
•
Enabling Interface
To assign an IP address to an interface, you need to enable the interface first. If the inter-
face is not enabled, you cannot access it from a remote place, even though an IP address
has been assigned.
To display if interface is enabled, use the command, show running-config.
Interface Configuration Mode
To open Interface Configuration mode of the interface you are about to enable interface,
use the following command.
Command
interface INTERFACE
To enable the interface, use the following command.
Command
no shutdown
The following is an example of enabling interface on Interface Configuration mode.
SWITCH# configure terminal
SWITCH(config)# interface 1
SWITCH(config-if)# no shutdown
SWITCH(config-if)#
Disabling Interface
To disable the interface, use the following commands on Interface Configuration mode.
Before disabling interface on Interface Configuration mode, you should open the mode,
and then use the follow command.
Command
shutdown
Mode
Global Opens Interface Configuration mode of the interface.
Mode
Interface Enables the interface on Interface Configuration mode.
Mode
Interface Disables an interface on Interface Configuration mode.
UMN:CLI
Description
Description
Description
57