Preempt - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
i
8.4.1.6
A50010-Y3-C150-2-7619
To configure an authentication password for security of Virtual Router, use the following
command on VRRP configuration mode.
Command
authentication clear_text
PASSWORD
no authentication
Authentication password can be configured with maximum 7 digits.
The following is an example of configuring Authentication password in Virtual Router as
network and showing it.
SWITCH(config-vrrp)# authentication clear_text network
SWITCH(config-vrrp)# show running-config
Building configuration...
(Omitted)
vrrp default 1
authentication clear_text network
associate 10.0.0.5
no snmp
SWITCH(config-vrrp)#

Preempt

Preempt is a function that an added device with the highest Priority user gave is auto-
matically configured as Master Router without rebooting or specific configuration when
you add an other device after Virtual Router is configured.
To configure Preempt, use the following command on VRRP configuration mode.
Command
preempt { enable | disable }
The following is an example of disabling Preempt.
SWITCH(config-vrrp)# preempt disable
SWITCH(config-vrrp)# exit
SWITCH(config)# show vrrp
default - virtual router 1
----------------------------------------------
state
virtual mac address
advertisement interval
preemption
priority
master down interval
[1] associate address : 10.0.0.5
SWITCH(config)#
Mode
Configures an authentication password.
VRRP
Deletes a configured authentication password.
Mode
VRRP Enables or disables Preempt. (default: enable)
master
00:00:5E:00:01:01
1 sec
disabled
100
3.624 sec
UMN:CLI
Description
Description
233