User Manual
SURPASS hiD 6615 S223/S323 R1.5
6.1.14
i
6.2
6.2.1
A50010-Y3-C150-2-7619
Assigning IP Address of FTP Client
Serveral IP addresses can be assigned on hiD 6615 S223/S323. But user can specify
one source IP address connecting FTP server when the switch is a client. To configure
FTP binding address as a source IP address when hiD 6615 S223/S323 as a client con-
nects to FTP server, use the following command.
Command
ftp bind-address A.B.C.D
no ftp bind-address
Please be careful that the FTP bind-address is also applied to TFTP server's bind-
address.
Configuration Management
You can verify if the system configurations are correct and save them in the system. This
section contains the following functions.
•
Displaying System Configuration
Saving System Configuration
•
Auto-Saving
•
System Configuration File
•
Restoring Default Configuration
•
Displaying System Configuration
To display a current running configuration of the system, use the following command.
Command
show running-config
show
running-config
rule | arp | bridge | dns | full |
hostname | instance | interface
INTERFACE I login | pm | qos |
rmon-alarm | rmon-event | rmon-
history | router { bgp | pim | rip |
ospf | vrrp } | rule | snmp | syslog
| time-out | time-zone | time-out }
show
running-config
{bgp | ospf | pim | rip | vrrp}
Mode
Binds a source IP address for connecting to FTP
server..
Global
Deletes FTP bind-address
Mode
Shows a configuration of the system.
{ admin-
Shows a configuration of the system with the specific
All
option.
Shows only the configuration that corresponds to each
router
option.
UMN:CLI
Description
Description
91