Displaying Mrib Information; Multicast Time-To-Live Threshold; Mrib Debug - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
9.1.4
9.1.5
9.1.6
A50010-Y3-C150-2-7619

Displaying MRIB Information

To display MRIB information, use the following commands
Command
show ip mroute { dense | sparse }
{ count | summary }
show ip mroute GROUP-ADDR
[SRC-IP-ADDRESS] { dense
sparse } { count | summary }
show ip mroute GROUP-ADDR
[SRC-IP-ADDRESS]
ADDR [SRC-IP-ADDRESS]{ dense
| sparse } { count | summary }
show ip mroute
ADDR/M { dense | sparse } { count
| summary }
To display the contents of the MRIB VIF table, use this command.
Command
show ip mvif [IFNAME]

Multicast Time-To-Live Threshold

Use this command to configure the time-to-live (TTL) threshold of packets being for-
warded out of an interface.
Command
ip multicast ttl-threshold
<0-255>
no ip multicast ttl-threshold

MRIB Debug

Use this command to debug events in the multicast RIB.
Command
debug nsm mcast { all | fib-msg |
mrt | register | stats | vif }
no debug nsm mcast { all | fib-
msg | mrt | register | stats | vif }
Mode
|
Displays multicast routes entries.
Enable
Global
GROUP-ADDR: group IP address
GROUP-
Bridge
SRC-IP-ADDRESS: source IP address
GROUP-
Mode
Enable Displays IP multicast interface.
Mode
Configures the time-to-live threshold for multicast
packet
interface
Default: 1
Restores is as a default.
Mode
Debugs event in the multicast RIB.
all : all Ipv4 multicast debugging
fib-msg: multicast FIB messages
mrt: multicast routes
register: multicast PIM register messages
Enable
stats: multicast statitics
vif: multicast interface
Disables the debug event.
UMN:CLI
Description
Description
Description
Description
281