Kat (Keep Alive Time) Of Rp; Ignoring Rp Priority; Pim-Sm Registration; Rate Limit Of Register Message - Siemens S223 User Manual

UMN:CLI
9.3.4.3
9.3.4.4
9.3.5
9.3.5.1
9.3.5.2
310

KAT (Keep Alive Time) of RP

You can configure KAT for (S, G) states at RP to monitor PIM Register packets, overriding
the generic KAT timer value.
Command
ip pim rp-register-kat <1-65535>
no ip pim rp-register-kat

Ignoring RP Priority

To ignore the RP-SET priority value, and use only the hashing mechanism for RP selec-
tion, use the following command. It is used to inter-operate with older Cisco IOS versions.
Command
ip pim ignore-rp-set-priority
no ip pim ignore-rp-set-priority

PIM-SM Registration

Rate Limit of Register Message

You can configure the rate of register packets sent by the designated router (DR), in units
of packets per second. Enabling this command will limit the load on the DR and RP at the
expense of dropping those register messages that exceed the set limit. Receivers may
experience data packet loss within the first second in which register messages are sent
from bursty sources.
The configured rate is per (S, G) state, not a system wide rate.
Command
ip pim register-rate-limit
<1-65535>
no ip pim register-rate-limit

Registeration Suppression Time

Use this command to configure the register-suppression time, in seconds, overriding the
default value of 60 seconds. Configuring this value modifies register-suppression time at
the DR, and configuring this value at the RP modifies the RP-keepalive-period value if the
ip pim re-register-kat command is not used.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Configures Keep Alive Time.
1-65535: time
Global
Disables a KAT configuration.
Mode
Ignores the PR-SET priority value.
Global
Deletes the priority ignoring configuration.
Mode
Configures the rate of register packets.
1-65535: the maximum number of packets that can be
Global
sent per second.
Disables the limit configuration.
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619