Vrrp Statistics; Rate Limit - Siemens S223 User Manual

UMN:CLI
8.4.1.7
8.5
234
Also, to make Preempt "enable" as default setting, use the following command on VRRP
configuration mode.
Command
no preempt

VRRP Statistics

To display the VRRP statistics that packets have been sent and received, use the follow-
ing command.
Command
show vrrp stat
The following is an example of viewing statistics of packets in Virtual Router Group.
SWITCH(config)# show vrrp stat
VRRP statistics :
VRRP packets rcvd with invalid TTL
VRRP packets rcvd with invalid version
VRRP packets rcvd with invalid VRID
VRRP packets rcvd with invalid size
VRRP packets rcvd with invalid checksum
VRRP packets rcvd with invalid auth-type 0
VRRP packets rcvd with interval mismatch 0
SWITCH(config)#
To clear the VRRP statistics information, use the following command.
Command
clear vrrp stat

Rate Limit

User can customize port bandwidth according to user's environment. By this configuration,
you can prevent a certain port to monopolize whole bandwidth so that all ports can use
bandwidth equally. Egress and ingress can be configured both to be same and to be dif-
ferent.
The hiD 6615 S223/S323 can apply the rate limit and support ingress policing and egress
shaping.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Deletes the former configuration of Preempt to enable
VRRP
it.
Mode
Enable
Global
Shows statistics of packets in Virtual Router Group.
Bridge
VRRP
0
0
0
0
0
Mode
Enable
Global
Clears statistics of packets in Virtual Router Group.
Bridge
VRRP
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619