User Manual
SURPASS hiD 6615 S223/S323 R1.5
7.3.6
A50010-Y3-C150-2-7619
Displaying LLDP Configuration
To display LLDP configuration, use the following command.
Command
show lldp config PORTS
show lldp remote PORTS
show lldp statistics PORTS
To delete an accumulated statistics on the port, use the following command.
Command
clear lldp statistics PORTS
The following is to configure to enable LLDP function on Bridge Configuration mode-
through port number 10 of the switch and operate it.
SWITCH(bridge)# show lldp config 10
GLOBL:
-----------------------------------------------------------------------
MsgTxInterval
= 30
MsgTxHold
= 4
ReInitDelay
= 2
TxDelay
= 2
-----------------------------------------------------------------------
PORTS active
adminStat|optTLVs
10: disable
SWITCH(bridge)# lldp enable 10
SWITCH(bridge)# lldp disable 10 portdescription
SWITCH(bridge)# lldp adminstatus 10 tx_only
SWITCH(bridge)# lldp msg txinterval 50
SWITCH(bridge)# lldp msg txhold 8
SWITCH(bridge)# show lldp config 10
GLOBL:
-----------------------------------------------------------------------
MsgTxInterval
= 50
MsgTxHold
ReInitDelay
= 2
TxDelay
= 2
-----------------------------------------------------------------------
PORTS active
adminStat|optTLVs
10: enable
SWITCH(bridge)#
Mode
Enable
Global
Bridge
Mode
Global
Bridge
=> txTTL = 120
Tx<->Rx|0xf= PortDesc, SysName, SysDesc, SysCap
= 8
=> txTTL = 400
Tx only |0xe= SysName, SysDesc, SysCap
Description
Shows LLDP configuration.
Show statistics for remote entries.
Shows LLDP operation and statistics.
Description
Deletes an accumulated statistics on the port.
UMN:CLI
125