Pim Join/Prune Interoperability; Cisco Router Interoperability; Checksum Of Full Pim Register Message; Fig. 9.7 In Case Multicast Source Not Directly Connected To Multicast Group - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
9.3.7
9.3.8
9.3.8.1
A50010-Y3-C150-2-7619

PIM Join/Prune Interoperability

To configure the TX interval of PIM/Join/Prune Message, use the following command.
Command
ip pim message-interval
<1-65535>
no ip pim message-interval

Cisco Router Interoperability

Checksum of Full PIM Register Message

Although source of multicast is not connected to multicast group, multicast communica-
tion is possible. In the below picture, First-Hop router directly connected to source can re-
ceive packet from source without (S, G) entry about source. The First-Hop router encap-
sulates the packet in Register message and unicasts to RP of multicast group. RP decap-
sulates capsule of Register message and transmits it to members of multicast group.
Source
Multicast Packet
First-Hop Router
Encapsulates the packet
in Register message
and unicasts
In Case Multicast Source not Directly Connected to Multicast Group
Fig. 9.7
Mode
Configures Join/Prune timer value.
1-65535: interval (unit: second)
Global
Disables TX interval configuration.
RP
Decapsulates capsule of
Register message and
transmits it
UMN:CLI
Description
313