UMN:CLI
6.2.2
!
6.2.3
6.2.4
92
The following is an example to display a configuration of syslog.
SWITCH# show running-config syslog
!
syslog start
syslog output info local volatile
syslog output info local non-volatile
!
SWITCH#
Saving System Configuration
If you change a configuration of the system, you need to save the changes in the system
flash memory. To save all changes of the system, use the following command.
Command
write memory
When you use the command, write memory, make sure there is no key input until [OK]
message appears.
Auto-Saving
In hiD 6615 S223/S323, it is possible to save the configuration automatically. To configure
the con-figuration periodically, use the following command.
Command
write interval <10-1440>
no write interval
System Configuration File
To manage a system configuration file, use the following command.
Command
copy running-config {FILENAME
| startup-config }
copy startup-config FILENAME
copy FILENAME startup-config
copy FILENAME1 FILENAME2
erase FILENAME
SURPASS hiD 6615 S223/S323 R1.5
Mode
All
Saves all changes in the system flash memory.
Mode
Saves auto-configuration periodically.
10-1440: auto-saving interval (Default: 10 minute)
Global
Disables auto-saving function.
Mode
Copies a running configuration file.
FILENAME: configuration file name
startup-config: startup configuration file
Copies a startup configuration file.
FILENAME: configuration file name.
Copies a specified configuration file to the startup con-
Enable
figuration file.
FILENAME: configuration file name
Copies a specified configuration file to another configu-
ration file.
Deletes a specified configuration file.
FILENAME: configuration file name
User Manual
Description
Description
Description
A50010-Y3-C150-2-7619