Restarting Rip; Udp Buffer Size Of Rip - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
10.3.14
10.3.15
A50010-Y3-C150-2-7619
To configure RIP authentication, use the following command.
Command
ip rip authentication key-chain
NAME
ip rip authentication mode { text |
md5 }
Command
ip rip authentication
STRING
To disable RIP authentication, use the following command.
Command
no ip rip authentication key-
chain NAME
no ip rip authentication mode
{ text | md5 }
no ip rip authentication string
STRING

Restarting RIP

Occasionally, you should restart RIP system only when the switch is still operating while
you manage and configure RIP. At this time, the switch reports the neighbors that RIP
system is being restarting. It keeps previous route information until the restarting is com-
plete in timer.
To restart RIP system only, use the following command.
Command
rip restart grace-period
<1-65535>
no rip restart grace-period
[<1-65535>]

UDP Buffer Size of RIP

RIP protocol exchanges the routing information between routers using UDP packets. The
hiD 6615 S323 can be configured theses UDP packets buffer size, use the following
Mode
Enables authentication for RIP v2 packets and to spec-
ify the set of keys that can be used on an interface.
NAME: name of key chain
Specifies the authentication mode.
text: sends a simple text password to neighbors. If a
Interface
neighbor does not have the same password, request
and updates from this system are rejected.
md5: sends an MD5 hash to neighbors. Neighbors
must share the MD5 key to decrypt the message and
encrypt the response.
Mode
Configures RIP authentication string which will be us-
ing on interface without Key chain. The string must be
string
Interface
shorter than 16 characters.
STRING: RIP authentication string
Mode
Disables authentication keys that can be used on an
interface.
Interface
Disables specified authentication mode.
Removes RIP authentication string which will be using
on interface without Key chain.
Mode
Restarts RIP system and set the period.
Global
Removes a configured period.
UMN:CLI
Description
Description
Description
Description
371