Disabling Snmp Trap - Siemens S223 User Manual

User Manual
SURPASS hiD 6615 S223/S323 R1.5
7.1.8.4
!
A50010-Y3-C150-2-7619
snmp trap dhcp-lease
snmp trap fan
snmp trap power
snmp trap module

Disabling SNMP Trap

To disable SNMP trap, use the following command.
Command
no snmp trap auth-fail
no snmp trap cold-start
no snmp trap link-up PORTS
[NODE]
no snmp trap link-down PORTS
[NODE]
no snmp trap cpu-threshold
no snmp trap port-threshold
no snmp trap temp-threshold
no snmp trap dhcp-lease
no snmp trap fan
no snmp trap power
no snmp trap module
When you use the no snmp command, all configurations concerning SNMP will be
deleted.
Configures the system to send SNMP trap when no
more IP address that can be assigned in the subnet of
DHCP server is left.
Configures the system to send SNMP trap when the
Global fan begins to operate or stops.
Configures the system to send SNMP trap when any
problem occurs in power.
Configures the system to send SNMP trap when there
is any problem in module.
Mode
Global Disables each SNMP trap.
UMN:CLI
Description
111