Table of Contents
Advertisement
Attribute
Ascend-FR-T391 (166)
Ascend-FR-T392 (167)
Framed-MTU (12)
Ascend-FR-DCE-N392
(162)
Ascend-FR-DCE-N393
(164)
Ascend-FR-Link-Status-
Dlci (106)
Examples of a UNI-DTE link interface
On a UNI-DTE interface, the MAX acts as the user side communicating with the network side
DCE switch. It initiates link management functions by sending a Status Enquiry to the UNI-
DCE device. Status Enquiries may include queries about the status of PVC segments the DTE
knows about, as well as the integrity of the datalink between the UNI-DTE and UNI-DCE
interfaces.
The UNI-DTE uses the values of the N391, N392, N393, and T391 parameters in the Frame-
Relay profile to define the timing of its Status Enquiries to the DCE and its link integrity
parameters. (These correspond to the Ascend-FR-N391, Ascend-FR-DTE-N392, Ascend-FR-
DTE-N393, and Ascend-FR-T391 attributes in a RADIUS profile.)
Figure 5-4 shows an example of the MAX with a UNI-DTE interface.
MAX 6000/3000 Network Configuration Guide
Defining Frame Relay link operations
Value
Link Integrity Verification polling timer. The value should be less
than that of Ascend-FR-T392. The default is 10, which indicates
that after Ascend-FR-N391 status requests spaced 10 seconds
apart, the UNI-DTE device requests a Full status report. Does not
apply when Ascend-FR-Type is Ascend-FR-DCE.
Interval in which Status Enquiry messages should be received
(from 5 to 30 seconds). The default T392 value is 15. An error is
recorded if no Status Enquiry is received within the specified
number seconds. Does not apply when Ascend-FR-Type is
Ascend-FR-DTE.
Maximum number of bytes the MAX can transmit in a single
packet across the link interface. Usually the default of 1532 is the
right setting. However, the far-end device might require a lower
number.
Number of errors which, if occurring in the number of DCE
monitored events specified by Ascend-FR-DCE-N393, causes the
network-side to declare the user-side procedures inactive. The
value should be less than that of Ascend-FR-DCE-N393 (which
can be from 1 to 10). Does not apply when Ascend-FR-Type is
Ascend-FR-DTE.
DCE monitored event count (from 1 to 10). The default is 4. Does
not apply when Ascend-FR-Type is Ascend-FR-DTE.
DLCI to use for LMI link management on the Frame Relay
datalink. Valid values are DLCI0 (the default) and DLCI1023.
Configuring Frame Relay
Preliminary January 4, 2001
5-9
Advertisement
Table of Contents
