Figure 4-5. Telnet Login And Remote Command Execution - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Ethernet Interface Operation
See Figure 4-5 and do these steps:
3. Enter the Telnet username and password (the default for both
parameters is comtech):
4. The LRS remote command sets or returns Local or Remote state in the
form x, where x=0, 1, 2, or 3:
• LRS=0 (Local)
• LRS=1 (Serial)
• LRS=2 (Ethernet)
• LRS=3 (Serial+Ethernet) (default value)
Use the LRS=2 remote command to set the remote access parameter for
Ethernet remote control.

Figure 4-5. Telnet Login and Remote Command Execution

You must assign a unique IP Address for each unit on the network
before connecting to an existing network. As the IP address may
need to be changed to something other than the factory default
setting, use the remote command IPA=xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is a valid IP address on the network where the unit is
to be installed, and yy is the range (typically, yy = 24).
Changing the IPA value requires that you cycle power on the unit,
and then start a new Telnet session using the new IP address.
See Chapter 5. SERIAL INTERFACE OPERATION for more information
about the LRS and IPA commands.
4–9
MN-LPOD
Revision 14