Connector 'J6 | Com1' (Remote Communications And Discrete Control Port); Table 2-8. Lpod 'J6 | Com1' Pin Assignments - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
System Connectors, Installation, and Startup
2.3.5 Connector 'J6 | COM1' (Remote Communications
and Discrete Control Port)
PS 1/PS 1.5
Mating connector:
MS3116J14-19P or ITT KPT06J14-19P

Table 2-8. LPOD 'J6 | COM1' Pin Assignments

Pin Name
A RS485_+RX
B RS485_-RX
C RS485_+TX
D RS485_-TX
E RS232_RD
F Ethernet TX+
G RS232_TD
H Ethernet TX-
J TX/RX Switch Drive 1 Pos Not for customer use
K GND
L SUMFLT In
M SUMFLT Out
N TX Switch Pos 1 Ind
P RX Switch Pos 1 Ind
R +24V
S System Mute Control
T Switch Common
U Ethernet RX-
V Ethernet RX+
The 'J6 | COM 1' discrete control
connector is the primary input for
controlling and monitoring the
LPOD. It is a 19-pin circular
connector, type MS3112E14-19S.
PS 2
Description
Pin 3 of DB9 female connector
Pin 3 of RJ45 female connector
Pin 2 of DB9 female connector
Pin 6 of RJ45 female connector
Ground (also Pin 5 of DB-9F connector)
Open when faulted, else +5VDC
When faulted, tied to Pin K, else open
Online/Offline indication
Not for customer use
Not for customer use
When AUX=1, unit is muted until this pin is tied to ground
(Pin K). When tied to ground, the unit unmutes. See the
AUX remote command in Chapter 5. SERIAL INTERFACE
OPERATION.
GND reference for Pin N
Pin 2 of RJ45 female connector
Pin 1 of RJ45 female connector
2–10
MN-LPOD
Revision 14