Connector 'J1 | Lband In' Or 'J1 | Tx In; Connector 'J2 | Rf Out; Table 2-1. 'J2 | Rf Out' Interface Type - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
System Connectors, Installation, and Startup

2.3.1 Connector 'J1 | LBAND IN' or 'J1 | Tx IN'

2.3.2 Connector 'J2 | RF OUT'

WARNING!
FOR SAFETY REASONS, NEVER LOOK DIRECTLY INTO THE WAVEGUIDE
OUTPUT.
The 'J2 | RF OUT' connector may be a waveguide or coaxial interface – the type
of interface used depends on the LPOD model and/or frequency range of the
unit. See Table 2-1 and Figure 2-1, Figure 2-2, or Figure 2-3.

Table 2-1. 'J2 | RF OUT' Interface Type

Unit Frequency Band
C
PS 1
X
Ku
C
PS 1.5 X
Ku
C
PS 2 X
Ku
The RF input connector is a Type 'N' female
connector. Labeled 'J1 | LBAND IN' on the
LPOD PS 1 and PS 1.5 models or 'J1 | Tx IN'
on the LPOD PS 2 unit, typical input levels (-
30 dBm) depend on desired output power
and unit attenuation. To prevent damage to
the LPOD, RF input levels should not exceed
+15 dBm.
Output Type
Type 'N' Female (Standard)
CPR137G (Optional)
CPR112G (Waveguide)
WR75 (Waveguide)
CPR137G (Waveguide)
CPR112G (Waveguide)
WR75 (Waveguide)
CPR137G (Waveguide)
CPR112G (Waveguide)
WR75 (Waveguide)
2–4
MN-LPOD
Revision 14
FIGURE
2-3
2-4
2-5