Table of Contents
Advertisement
Appendix A. 1:1
REDUNDANCY
A.1 LPOD Redundancy Operation Overview
The LPOD Outdoor Amplifier / Block Up Converter can configured for 1:1
redundancy by connecting the appropriate 1:1 Redundancy Cable to the 'J6 |
COM1' connector (see Chapter 2. SYSTEM CONNECTORS, INSTALLATION
AND
STARTUP).
Once you set up a 1:1 Redundancy System, use the proper serial remote
commands or HTTP Interface page controls to place the units into Redundancy
Mode. The system automatically configures the backup (offline) unit by copying
the configuration from the active (online) unit.
A–1
Advertisement
Table of Contents
