Table of Contents
Advertisement
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Serial Interface Operation
5.4 Remote Commands and Queries
Attenuation, 5–12
Attenuation Offset, 5–12
Auto Fault Recovery, 5–12
Auxiliary Mute Enable, 5–13
Calibrate LNB Current, 5–15
Circuit Identification, 5–15
Clear All Stored Alarms, 5–13
Clear All Stored Events, 5–13
Clear Statistics Log, 5–16
Clear Trending Data, 5–16
Concise Alarm Status, 5–13, 5–14
Concise Configuration Status, 5–14
Concise Maintenance Status, 5–15
Concise RF Power FET Current Status, 5–14
Concise Utility Status, 5–16
Enable Redundancy Switch Mode, 5–17
Enable Statistics Averaging, 5–17
Enable Statistics Logging, 5–17
External Reference Mute, 5–33
FSK Address, 5–30
Gateway IP Address, 5–19
Global Amplifier Configuration, 5–18
Initialize Events Pointer, 5–18
Initialize Statistics Pointer, 5–19
LNB Current Source, 5–19
LNB Current Window, 5–20
LNB Current Window Enable, 5–16
Local/Remote State, 5–21
Low Forward Power Threshold, 5–20
MAC Address, 5–21
Management IP Address, 5–19
Maximum Operating Point, 5–21
Mute State, 5–22
Number of Unread Events, 5–22
Number of Unread Statistics, 5–22
Offline Mute, 5–23
Online Status, 5–23, 5–25
Part Number, 5–23
Reboot Command, 5–24
Reference Oscillator Tuning, 5–25
Remote Baud Rate, 5–29
Retrieve Alarm Status, 5–24
Retrieve Configuration Status, 5–25
Retrieve Equipment Type, 5–25
Retrieve Firmware Number, 5–18
Retrieve Maintenance Status, 5–27
Retrieve Next 5 Events, 5–28
Retrieve Next 5 Statistics, 5–29
Retrieve next 5 unread Stored Alarms, 5–
20
Retrieve Number of unread Stored
Alarms*, 5–32
Retrieve Number of Unread Stored Events,
5–32
Retrieve Utility Status, 5–29
RF Power Amplifier State, 5–12
5–10
RF Power FET Current status, 5–26
Serial Number, 5–29
Serial Number*, 5–30
Set Physical (remote) Address, 5–30
Set RTC Date (by Day), 5–17
Set RTC Date (by Month)*, 5–16
Set RTC Time, 5–32
SNMP Authentication Trap Enable, 5–30
SNMP Enable, 5–30
SNMP Read Community, 5–31
SNMP System Contact, 5–31
SNMP System Location, 5–31
SNMP Trap Destination IP Address 1, 5–31
SNMP Trap Destination IP Address 2, 5–31
SNMP Trap Version, 5–31
SNMP Unit Name, 5–31
SNMP Write Community, 5–31
Software Image Selection, 5–19
Software Revision, 5–32
Statistics Interval, 5–31
Summary Fault Status, 5–30
Switch Bias Tee, 5–30
Temperature, 5–32
Terminal Status Change, 5–33
Time Protocol Enable, 5–32
Time Protocol Serve, 5–32
Unit Alarm Mask, 5–22
MN-LPOD
Revision 14
Advertisement
Table of Contents
