Comtech EF Data LPOD PS 1.5 Installation And Operation Manual page 168

Outdoor amplifier/block up converter buc, for firmware ver. 1.5.6 or higher
Hide thumbs Also See for LPOD PS 1.5:
Table of Contents

Advertisement

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Appendix A
Auto Fault Recovery (AFR)
Amplifier state (AMP)
Attenuation (ATT)
Auxiliary Mute (AUX)
LNB Current Window Enable (CWE)
Date (DAY)
• *
Enable Statistics Averaging (ESA)
Enable Statistics Logging (ESL)
• LNB Current Source enable (LCS)
LNB Current Window (LCW)
* Day and Time are updated only when the inter-unit redundancy
link is either established or re-established.
The position of the Tx Waveguide Switch determines the online status of a unit
in a 1:1 Redundancy System. When the switch is oriented to allow a unit to send
RF power to the antenna (as determined by the switch's failsafe indicator), the
unit is considered to be online. Otherwise, the unit is considered to be offline.
When redundancy mode is disabled (ESW=0), the unit always reports that it is
online. This is because, in standalone mode, there are no waveguide switches
monitored and controlled by the unit. Standalone mode does not use the Tx
waveguide switch position to determine online status.
Only the offline unit is allowed to initiate a redundant switchover by throwing
the waveguide switches. The offline unit will initiate a redundant switchover if
any of the following conditions are met:
• Online unit faulted, and offline unit is not faulted.
• Inter-unit redundancy link established, and then timed out.
• Mismatched waveguide switch condition is detected.
• Unit is forced online through a remote command.
If you enable Offline Mute (OFM), then the unit will mute the RF Output when it
is offline. The OFM state also affects the LNB Bias Tee Switch position, because
the switch serves as the unit's Rx path mute, so it is therefore tied to the Mute
State (MUT) of the unit while the unit is running in redundancy mode (i.e., if
• Low Power Threshold (LPT)
• Local / Remote Setting (LRS)
• User fault mask (MSK)
• RF mute (MUT)
• Offline Mute (OFM)
• Remote LNB Control (RLC)
• Set Baud Rate (SBR)
• Set Statistics Interval (SSI)
Time (TIM)
*
• External Reference Mute (XRM)
A–6
MN-LPOD
Revision 14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lpod ps 1Lpod ps 2Lpod

Table of Contents