Table of Contents
Advertisement
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Serial Interface Operation
Controller-to-Target
Instruction Code and
Parameter Type
Qualifier
(* indicates
End-of-Life)
Command
Query
Retrieve Alarm
N/A
RAS?
Status
Reboot
RBT=
N/A
Arguments for
Command or
Query
168 bytes
Query only.
Returns the Alarm status of the unit, where:
OK=No fault condition; FT=Faulted; AL=Alarm; YS=Yes; NO=No; MS=Masked.
EXAMPLE:
<0001/RAS?{CR}
>0001/RAS={CR}
P24V1=OK{CR} (+24V power supply)
P24V2=NA{CR} (+24V switch power supply)
LNBVT=XXXXX{CR} (+13/18V LNB power supply) (SEE NOTE)
P13VT=OK{CR} (+13.5V power supply)
P10V1=OK{CR} (+10V power supply)
A10V1=OK{CR} (+10V1 RF supply) (SEE NOTE)
A10V2=NA{CR} (+10V2 RF supply) (SEE NOTE)
P7V8T=OK{CR} (+7.8V power supply)
P5V8T=OK{CR} (+5.8V power supply)
P2V5T=OK{CR} (+2.5V power supply)
P1V2T=OK{CR} (-1.2V power supply)
N5V8T=OK{CR} (-5.8V power supply)
FANR1=OK{CR} (Fan 1 speed) (SEE NOTE)
FANR2=OK{CR} (Fan 2 speed) (SEE NOTE)
ATEMP=OK{CR} (Amplifier temperature)
SHTDN=OK{CR} (Over-temp shutdown)
IICST=OK{CR} (I2C bus status)
FWPWR=OK{CR} (Forward power in dBm)
CHKSM=OK{CR} (Flash checksum)
FPGAD=NA{CR} (FPGA done status)
BUCLD=OK{CR} (BUC lock detect) (SEE NOTE)
REFLD=NA{CR} (Reference lock detect) (SEE NOTE)
LNBCS=XXXXX{CR} (LNB current status) (SEE NOTE)
SWITC=NA{CR} (Waveguide switch position status) (SEE NOTE)
RDLNK=NA{CR} (Redundancy link status) (SEE NOTE)
TRMST=YS{CR}{LF} (Terminal Status)
NOTE: LNBVT, A10V1, A10V2, FANR1, FANR2, BUCLD, REFLD, LNBCS, SWITC and RDLNK only appear in the list if
the appropriate model/options have been selected/installed.
1 byte
Command only.
Soft Reboots the unit in the form x where:
1=Reboot System
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
5–23
MN-LPOD
Revision 14
Target-to-Controller
(see Description of Arguments)
Response to
Response to
Command
Query
RAS=
RAS=x....x
RBT =
RBT=x
RBT?
RBT*
Advertisement
Table of Contents
