Get The Lpod Management Ip Address And Firmware Information; Use The Http Interface To Find The Firmware Information - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Firmware Update
• Port Flow Control = NONE
• Display New Line Rx/Tx = CR
Read your terminal emulator program user guide or HELP feature for
operating and configuration instructions.
3.2.3 Get the LPOD Management IP Address and
Firmware Information
Do these steps:
1. On the LPOD – Apply power to the unit. Your power connection varies
depending on your ordered unit.
See Section 2.2.3 or Section 2.2.4 in Chapter 2. SYSTEM
CONNECTORS, INSTALLATION,
identify your specific power connector.
2. Identify your default Management IP Address. You will not be able to
access the LPOD HTTP (Web Server) Interface without this information.
3. Get the firmware information using either of these methods:
• To use the HTTP Interface, see Section 3.2.3.1.
• To use the Serial Remote Interface, see Section 3.2.3.2.

3.2.3.1 Use the HTTP Interface to Find the Firmware Information

Chapter 4. ETHERNET INTERFACE OPERATION
Do these steps:
1. Go to one of these pages to review the firmware information:
• The 'Firmware Information' section of the 'Config | Utility' page
provides the firmware details as Boot, Bulk1, and Bulk2, as shown
in this example:
STARTUP in this manual to
AND
3–5
MN-LPOD
Revision 14