Configure Hyperterminal For Telnet Remote Control Operation4-7; Figure 4-2. Telnet Interface Example – Hyperterminal - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Ethernet Interface Operation
Figure 4-2. Telnet Interface Example – HyperTerminal
4.3.1.1 Configure HyperTerminal for Telnet Remote Control
Operation
Figure 4-3. Configure HyperTerminal
See Figure 4-3. Do these steps:
1. Make sure to define the Connect To Telnet connection properties
correctly (File  Properties) (Figure 4-3, left):
a. Enter the LPOD's Traffic/Management IP Address as the "Host
address" (e.g., 192.168.1.1).
4–7
MN-LPOD
Revision 14