Connector 'J3 | Power In' Dc Power Mains; Lpod Ps 1 'J3 | Power In' Dc Power Main; Table 2-4. Lpod Ps 1 'J3 | Power In' Pin Assignments - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
System Connectors, Installation, and Startup

2.3.4 Connector 'J3 | POWER IN' DC Power Mains

WARNING!
FOR SAFETY REASONS, MAKE SURE YOU KNOW THAT THE 'J3 |
POWER IN' DC POWER CONNECTION PIN ASSIGNMENTS ARE
DIFFERENT FOR EACH LPOD UNIT. YOU MUST USE THE CORRECT PIN
ASSIGNMENTS.
INCORRECT USE OF PIN ASSIGNMENTS CAN RESULT IN PRODUCT
DAMAGE OR PERSONAL INJURY.
For all LPOD models, the prime power input requirement is 38-72V DC. The total
power required from the prime power supply depends on the model used. See
Sect. 1.5 Summary of Specifications for more information.

2.3.4.1 LPOD PS 1 'J3 | POWER IN' DC Power Main

The mating connector specification and the pin assignments (Table
2-4) specific to the LPOD PS 1 DC power interface are as follows:
Mating Connector:
CEFD P/N CN/STPG04F01 (Glenair IPT06E-12-4-SSR-F7)

Table 2-4. LPOD PS 1 'J3 | POWER IN' Pin Assignments

Pin
A
B
C
D
LPOD PS 1 Assignment
V+
GND
V-
NO CONNECT
2–7
MN-LPOD
Revision 14