Table of Contents
Advertisement
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter
Appendix C
Step
Task
6
Reconnect the fan power supply by pressing the male and female
connectors together until the locking mechanism snaps and locks – see
Figure C-7.
7
Re-install the fan shroud onto the chassis – make sure that you keep
the fan power supply cable clear of the fan and heat sink surfaces.
Then, re-install the eight screws as described in Step 2.
Torque the screws to 11 ±2 inch lbs.
8
Reconnect the power source to the LPOD.
Figure C-3. LPOD PS 1 Shroud Screw Locations
C–3
MN-LPOD
Revision 14
Advertisement
Table of Contents
