Steps To Update The Lpod Unit - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Firmware Update
3.4.4

Steps to Update the LPOD Unit

Chapter 4. ETHERNET INTERFACE OPERATION
Use the LPOD HTTP Interface to select the new firmware and soft-reboot the
unit. Go to the 'Config | Utility' page and do these steps:
1. Select the preferred Current Active Firmware Image:
a. Use the 'Next Reboot Image' drop-down list to select Image 1 or 2.
b. Click [Submit].
2. Soft-reboot the LPOD:
a. In the 'Perform Soft Reboot' section, click [Reboot Now].
b. Wait while the LPOD reboots with the Current Active Firmware Image.
3. To load a second image, repeat Steps 1 and 2.
4. After the unit has rebooted with the new firmware, you must clear the
trending data. To do this, use the terminal emulator or CLC-10 Handheld
Terminal to enter serial remote command "<0/CTD=1{CR}".
The LPOD is now operating with its latest firmware. The firmware update process
is complete.
3–15
MN-LPOD
Revision 14