Applicable Serial-Based Redundancy Commands And Queries; Troubleshooting Connectivity Issues - Comtech EF Data LPOD PS 1.5 Installation And Operation Manual

Outdoor amplifier/block up converter buc, for firmware ver. 1.5.6 or higher
Hide thumbs Also See for LPOD PS 1.5:
Table of Contents

Advertisement

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Appendix A
Online Unit, the LNB Bias Tee setting is driven by that unit's Tx Mute
setting (MUT) – If MUT=0, then SBT=1; if MUT=1, then SBT=0.
• LCS=0 (the LNB Current Source is DISABLED – no voltage transmitted), or,
if so equipped, 1-4 (where the selected LNB Current Source is 1=18V 22
kHz Disabled; 2=18V 22 kHz Enabled; 3=13V 22 kHz Disabled; or 4=13V 22
kHz Enabled).
For the Offline Unit tabulation: The Offline Unit monitors the Online Unit
control settings and updates its settings every few seconds. As tabulated,
"FOLLOW" means that this Offline Mute control setting "follows" the Online
Unit's corresponding Offline Mute control. However, when an Offline Unit
control setting is listed as either "0" (disabled/OFF) or "1" (enabled/ON), this
means the Offline Mute selection "forces" this value and does not
Online Unit's configuration.
A.2.2.1 Applicable Serial-Based Redundancy Commands
and Queries
These serial remote commands and queries apply to redundancy operations:
Remote
Meaning
Command
Redundancy
RED
Online/Offline
Enable Switch
ESW
Mode
Auto Fault
AFR
Recovery
AOF
Attenuation Offset
A.2.3

Troubleshooting Connectivity Issues

Each network is unique, and network configuration and management
are outside the scope of this manual. This information is provided as a
helpful troubleshooting tool, but trained network specialists may be
required to make an Ethernet-enabled product work in a specific
network. This section offers common solutions to network
Functional Description
Reports the appropriate unit's online/offline status.
Also used to force a unit to go active (online).
Puts the unit into redundancy or standalone (manual)
mode.
Sets the latching state of faults. Either they will latch
to the faulted state or they will recover automatically.
Individual attenuation command, used to adjust out
small differences in power levels of different amplifier.
A–8
MN-LPOD
Revision 14
follow the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lpod ps 1Lpod ps 2Lpod

Table of Contents