Telephone Switchpack-Renew - Aston Martin V8 Vantage Workshop Manual

2. Remove RH luggage compartment carpet (see
Workshop Manual procedure 01.05.FB Carpet
Assembly - Luggage Compartment - Side - RH - Renew).
3. Remove bolt (x1) and nuts (x2) from power socket
bracket to body (see Fig. 1).
4. Release power socket bracket and position aside.
5. Remove Torx screws (x6) from amplifier bracket to body
(see Fig. 2).
6. Release clip that secures lamp harness to amplifier
bracket.
7. Disconnect harness to luggage compartment lamp and
remove lamp assembly.
8. Release power amplifier bracket from body and
disconnect harness multiplugs (x3).
9. Remove amplifier and bracket assembly.
10. Disconnect multiplugs (x3) from amplifier to audio
harness.
October 2005
Fig. 1
Fig. 2
Workshop Manual
11. Remove bolts (x4) that secure subwoofer amplifier to
mounting plate and remove amplifier (see Fig. 3).
Installation
1. Install amplifier to mounting plate.
2. Connect multiplugs (x3) from amplifier to audio harness.
3. Position amplifier and bracket assembly to body and
connect multiplugs (x3).
4. Secure luggage compartment lamp harness and connect
and install lamp assembly.
5. Install Torx screws (x6) from amplifier bracket to body.
6. Position power socket bracket to body and install bolt
(x1) and nuts (x2).
7. Install RH luggage compartment carpet (see Workshop
Manual procedure 01.05.FB Carpet Assembly - Luggage
Compartment - Side - RH - Renew).
8. Battery isolation switch 'ON'.

Telephone Switchpack-Renew

Repair Operation Time (ROT)
Item
Telephone Switchpack-Renew
Removal
1. Remove centre stack assembly and centre stack support
bracket.
2. Remove Infotainment Control Module (see Workshop
Manual procedure 15.01.CF Infotainment Control
Module - Renew).
3. Remove phone switchpack securing screws (x2) and
multiplug (x1)
Installation
1. Install phone switchpack and secure with screws (x2).
2. Connect multiplugs (x10).
3. Install Infotainment Control Module (see Workshop
Manual procedure 15.01.CF Infotainment Control
Module - Renew).
4. Install centre stack support bracket and centre stack
assembly.
Fig. 3
Code
15.01.CE
15-1-3