Transmission Control Module - Renew (Tcm) - Aston Martin DB7 Workshop Manual

Electrics
Transmission Control Module
"3^^
6.7.06 Transmission Control Module
Renew (TCM)
Data
Torque Figures
Nut TCM to mounting bracket 2-3 Nm
Procedure
Disconnect the battery.
1.
2.
3.
Remove the rear seat squab. Remove the rear
quarter trim and the rear quarter lower trim pad.
Remove the TCM to mounting bracket securing
nuts (Fig. 1 -2) and remove one bracket.
Figure 1
4. Remove the TCM and mounting bracket assembly
from the body mounting bracket (Fig. 1-1).
5. Disconnect the TCM multi plug (Fig. 1-4) and
remove the TCM.
6. Fit and align the left mounting bracket (Fig. 1 -5) to
the new TCM, and secure with two nuts. Connect
the harness multi plug (Fig. 1-4) to the TCM. Fit the
TCM and left mounting bracket assembly to the
body mounting bracket (Fig. 1-1), ensure the left
bracket slot is fully seated.
7. Fit the right mounting bracket (Fig. 1 -3) to the TCM
and to the body mounting bracket. Secure with two
nuts.
8. Refit the rear quarter lower trim pad.
9. Refit the rear quarter trim panel.
10. Refit the rear seat squab.
11. Reconnect the battery.
6-16
May 1996