Body System (01.00)
Mirrors (01.09)
Specifications
Torque Figures
Description
Mirror Mounting
Maintenance
RH/LH Door Mirror Assembly-Renew
Repair Operation Time (ROT)
Item
Door Mirror Assembly-Renew
Door Mirror Assembly-Renew
Removal
1. Remove door trimboard (see Workshop Manual
procedure 01.05.CB Trimboard Assembly - Door -
Remove for Access & Refit).
2. Lift rear of fixed window, remove rubber surround at
top and pull out window.
3. Remove the door mirror rubber cheater panel.
4. Disconnect multiplug and release harness from fir tree
clips (x2) and self adhesive clip.
5. Remove Torx bolts (x3) and screw from glass channel,
remove mirror assembly.
Installation
1. Position mirror, install and torque tighten Torx bolts (x3)
and screw (glass channel).
2. Connect multiplug and secure harness fir tree clips (x2)
and self adhesive clip.
3. Install rubber mirror cheater panel and insert rubber
guttering.
4. Refit fixed window, ensure rubber surround is correctly
installed.
5. Install door trimboard (see Workshop Manual procedure
01.05.CB Trimboard Assembly - Door - Remove for
Access & Refit).
Door Mirror Glass and Pad Assembly-
Renew
Repair Operation Time (ROT)
Item
Door Mirror Glass and Pad Assembly-
Renew
Door Mirror Glass and Pad Assembly-
Renew
Removal
1. Switch ignition on, motor mirror fully inwards, switch off
ignition.
2. Support outer edge of mirror glass, using a suitable flat
blade between inboard glass edge and casing, lever glass
outwards to release from outboard clip.
October 2005
3. Turn on ignition and drive mirror to maximum away
from door, turn off ignition and disconnect lucar
connectors (x2).
Installation
1. Connect lucar connectors to mirror glass (x2).
Nm
2. Align mirror glass inboard clip with pad and fit white
20-25
tags into their appropriate channels.
3. Press outboard edge of mirror glass until it can be heard
to clip into place.
Code
RH
01.08.GC
LH
01.08.GD
Code
RH
01.08.GE
LH
01.08.GF
Workshop Manual
Mirrors (01.09)
Body System (01.00)
1-6-1