Front Undertray-Renew; Rear Undertray-Renew; Undertray Vehicle Set-Renew; Rh/Lh Front Wheel Arch Liner-Renew - Aston Martin V8 Vantage Workshop Manual

Exterior Trim (01.08)
Body System (01.00)
3. Install LH front wheel arch liner (see Workshop Manual
procedure 01.02.FB Wheel Arch Liner - Front - LH -
Renew).

Front Undertray-Renew

Repair Operation Time (ROT)
Item
Front Undertray-Renew
Removal
1. Raise vehicle on ramp.
2. Remove screws (x2),Torx screws (x12), front undertray
to body.
3. With assistance, remove front undertray.
Installation
1. With assistance, install undertray, install and tighten
Torx screws (x12) to (19-26 Nm) and screws (x2) to (8­
10 Nm)
2. Lower vehicle on ramp.

Rear Undertray-Renew

Repair Operation Time (ROT)
Item
Rear Undertray-Renew
Removal
1. Raise vehicle on ramp.
2. Remove Torx screws (x10), rear undertray to subframe.
3. Remove rear undertray.
Installation
1. Install rear undertray, install and tighten Torx screws
(x10) to (8-10 Nm).
2. Lower vehicle on ramp.

Undertray Vehicle Set-Renew

Repair Operation Time (ROT)
Item
Undertray Vehicle Set-Renew
Removal
1. Raise vehicle on ramp.
2. Remove Torx screws (x12), screws (x2), front undertray
to subframe.
3. With assistance, remove front undertray.
4. Remove Torx screws (x10), rear undertray to subframe.
5. Remove rear undertray.
Installation
1. With assistance, install front undertray, install and
tighten Torx screws (x12), screws (x2).
2. Install rear undertray, install and tighten Torx screws
(x10).
3. Lower vehicle on ramp
1-5-2

RH/LH Front Wheel Arch Liner-Renew

Repair Operation Time (ROT)
Item
Wheel Arch Liner-Renew
Wheel Arch Liner-Renew
Code
Removal
01.02.NB
4. Raise vehicle on ramp.
5. Remove road wheel(s).
6. Remove screws (x23), wheel arch liner to body.
7. Release and remove wheel arch liner.
8. Remove inner pad from liner.
Installation
1. Install inner pad to wheel arch liner.
2. Install wheel arch liner, fit and tighten screws (x23).
3. Install road wheel(s).
4. Lower vehicle on ramp.

RH/LH Rear Wheel Arch Liner-Renew

Repair Operation Time (ROT)
Item
Code
Rear Wheel Arch Liner-Renew
01.02.PB
Rear Wheel Arch Liner-Renew
Removal
1. Raise vehicle on ramp.
2. Remove road wheel(s).
3. Release vent pipe clips (x2) - Right-hand side only.
4. Remove screws (11), wheel arch liner to body.
5. Release and remove wheel arch liner, remove inner pad
from liner.
Installation
1. Install inner pad to wheel arch liner.
2. Install wheel arch liner, fit and tighten screws (x11).
Code
3. Install vent pipe to liner, clips (x2) - Right-hand side
01.02.PD only.
4. Install road wheel(s).
5. Lower vehicle on ramp.
Workshop Manual
Code
RH 01.02.GB
LH 01.02.FB
Code
RH 01.02.HB
LH 01.02.JB
October 2005