Rear Header Panel Assembly-Renew; Door Trimboard Assembly-Renew; Door Trimboard Assembly-Remove For Access/Refit4-3 - Aston Martin V8 Vantage Workshop Manual

2. Remove screw securing courtesy light console to header
(see Fig. 1).
3. Remove courtesy light console from header.
4. Remove sun visor allen screws (x2) (see Fig. 2).
5. Remove sunvisor.
Installation
1. Position sun visor and install screws (x2).
2. Install courtesy light console.
3. Install grille.

Rear Header Panel Assembly-Renew

Repair Operation Time (ROT)
Item
Rear Header Panel Assembly-Renew
Removal
1. Remove LH moulding assembly quarter trim upper (see
Workshop Manual procedure 01.05.CY Moulding
Assembly - Quarter Trim Upper - LH - Renew).
2. Remove RH moulding assembly quarter trim upper (see
Workshop Manual procedure 01.05.CX Moulding
Assembly - Quarter Trim Upper - RH - Renew).
3. Remove rear header panel assembly.
October 2005
Fig. 1
Fig. 2
Code
01.05.BK
Workshop Manual
Installation
1. Install rear header panel assembly.
2. Install RH moulding assembly quarter trim upper (see
Workshop Manual procedure 01.05.CX Moulding
Assembly - Quarter Trim Upper - RH - Renew).
3. Install LH moulding assembly quarter trim upper (see
Workshop Manual procedure 01.05.CY Moulding
Assembly - Quarter Trim Upper - LH - Renew).

Door Trimboard Assembly-Renew

Repair Operation Time (ROT)
Item
Door Trimboard Assembly-Renew
Removal
1. Lower door glass fully.
2. Disconnect vehicle battery.
3. Release door handle (bolts x2).
4. Remove door handle trim plate and disconnect door
catch inner release cable and remove bolts (x2) from
outer retaining plate.
5. Remove screw (x1) securing trim panel to top front of
door frame.
6. Remove door trim panel bolts (x5).
7. Lift trim out and up to release trim from door frame and
disconnect multiplugs (x2).
Installation
1. Position door trim panel and connect harness
multiplugs.
2. Place trim over top of retaining clips and pull out and
down to fit panel.
3. Install the door trim panel screws (x5).
4. Install screw (x1) trim panel to top front of door frame.
5. Connect release cable and position door handle trim
plate.
6. Install door handle (Bolts x2).
7. Connect vehicle battery.
Door Trimboard Assembly-Remove for
Access/Refit
Repair Operation Time (ROT)
Item
Door Trimboard Assembly-Remove/
Refit
Removal
1. Lower door glass fully.
2. Disconnect vehicle battery.
3. Release door handle (bolts x2).
4. Remove door handle trim plate and disconnect door
catch inner release cable and remove bolts (x2) from
outer retaining plate.
5. Remove screw (x1) securing trim panel to top front of
door frame.
Interior Trim (01.05)
Body System (01.00)
Code
01.05.CA
Code
01.05.CB
1-4-3