Aston Martin V8 Vantage Workshop Manual page 179

Road Wheels and Tyres (04.04)
Suspension (04.00)
Tyre Rotation
The road wheels and tyres are asymmetrical and
different sizes front and rear. They must not be rotated
front to rear. This function should be used only to verify
correct tyre position. Do not change the programmed
1. Press 'Set' for 2 seconds to enter level 1 programming.
2. Press 'Mode' repeatedly until 'Tyre Rotation' icon is
displayed.
3. Press 'Tyre' to scroll to a tyre position. Press 'Mode' to
display the current sensor identity.
Each sensor is identified by the colour of a washer on the
tyre valve. Tyres are always installed in fixed positions and
must remain as follows:
• Right Front - Green (Code 1)
• Left Front - Red (Code 2)
• Right Rear - Blue (Code 3)
• Left Rear - Yellow (Code 4)
If the current data is incorrect, revise as follows:
4. Ensure that the road wheels and tyres are installed in the
correct locations (see the colour code list above). Note
the correct code number for each road wheel.
5. Use 'Tyre' or 'Mode' to correct the sensor identity code
if required.
6. Repeat for the remaining tyres.
7. Press 'Set' twice to exit the programme.
Low Pressure Warning
1. Press 'Set' for 2 seconds to enter level 1 programming.
2. Press 'Mode' repeatedly until 'Flat Tyre' icon is
displayed.
3. Press 'Tyre' to scroll to the desired axle. Press 'Mode' to
display the current low pressure warning value.
4. Press 'Tyre' to increase or 'Mode' to decrease current
value.
4-5-10
Warning
data.
36-5-049
PSI
36-5-043
5. Press 'Set' to enter the new value into memory.
Pressure Deviation Alert
This function sets the threshold for warning of a deviation
from normal tyre pressures.
1. Press 'Set' for 2 seconds to enter level 1 programming.
2. Press 'Mode' repeatedly until the '+-' icon is displayed.
3. Press 'Tyre' to display the current value.
4. Press 'Tyre' to increase or 'Mode' to decrease the
current value
5. Press 'Set' to save the amended value.
6. Press 'Set' again to revert to normal operation.
High Temperature Alert
1. Press 'Set' for 2 seconds to enter level 1 programming.
2. Press 'Mode' until 'alert' icon is displayed.
3. Press 'Tyre' to display the current value of the high
temperature alert.
4. Press 'Tyre' to increase or 'Mode' to decrease current
value
5. Press 'Set' to save the amended value.
6. Press 'Set' again to return to normal mode.
Units Selection
Use this function to select the combination of units for
pressure and temperature.
1. Press 'Set' for 2 seconds to enter level 1 programming.
Workshop Manual
PSI
36-5-047
36-5-044
Bar
36-5-050
October 2005