Climate Subsystem (12.04); Maintenance; Solar Load Sensor-Renew; In-Car Temperature Sensor-Renew - Aston Martin V8 Vantage Workshop Manual

Climate Control (12.00)

Climate Subsystem (12.04)

Maintenance

Solar Load Sensor-Renew

Repair Operation Time (ROT)
Item
Solar Load Sensor-Renew
Removal
1. Remove IP unit from vehicle (see Workshop Manual
procedure 01.12.AB Facia Assembly - LHD - Remove
for Access & Refit).
2. Disconnect multiplug from solar sensor and remove
sensor from IP unit.
Installation
1. Install solar sensor, install multiplug.
2. Install IP unit into vehicle (see Workshop Manual
procedure 01.12.AB Facia Assembly - LHD - Remove
for Access & Refit).

In-car Temperature Sensor-Renew

Repair Operation Time (ROT)
Item
In-car Temperature Sensor-Renew
Removal
1. Release and remove driver's side lower instrument
panel, clips (x7), disconnect air temperature pipe.
Remove driver's lower panel assembly.
2. Disconnect multiplug, remove temperature sensor.
Installation
1. Install temperature sensor, connect multiplug.
2. Install driver's lower panel assembly.
Ambient Air Temperature Sensor-Renew
Repair Operation Time (ROT)
Item
Ambient Air Temperature Sensor-Renew
Removal
1. Remove radiator grille (see Workshop Manual
procedure 01.08.AA Grille - Radiator - Renew).
2. Release ambient air temperature sensor from body.
3. Disconnect multiplug, remove ambient air temperature
sensor.
Installation
1. Position ambient air temperature sensor, connect
multiplug, install sensor in body.
2. Install radiator grille (see Workshop Manual procedure
01.08.AA Grille - Radiator - Renew).
October 2005

A/C Re-circulation Switch-Renew

Repair Operation Time (ROT)
Item
A/C Re-circulation Switch-Renew
Removal
Code
1. Remove centre stack assembly (see Workshop Manual
12.04.AA
procedure 15.01.CB Centre Stack Assembly - Remove
for Access and Refit).
2. Depress clips and remove A/C re-circulation switch from
centre stack.
Installation
1. Install A/C re-circulation switch and secure with clips.
2. Install centre stack assembly (see Workshop Manual
procedure 15.01.CB Centre Stack Assembly - Remove
for Access and Refit).

A/C Request Switch-Renew

Repair Operation Time (ROT)
Item
A/C Request Switch-Renew
Removal
Code
1. Remove centre stack assembly (see Workshop Manual
12.04.AD
procedure 15.01.CB Centre Stack Assembly - Remove
for Access and Refit).
2. Depress clips and remove A/C request switch from
centre stack.
Installation
1. Install A/C request switch and secure with clips.
2. Install centre stack assembly (see Workshop Manual
procedure 15.01.CB Centre Stack Assembly - Remove
for Access and Refit).

HVAC Control Module-Renew

Repair Operation Time (ROT)
Item
Code
HVAC Control Module-Renew
12.04.AC
Removal
1. Remove centre stack assembly (see Workshop Manual
procedure 15.01.CB Centre Stack Assembly - Remove
for Access & Refit).
2. Rotate HVAC control knobs to vertical position, remove
screws (x8) securing HVAC control unit and multiplugs
(x2); (lever HVAC unit from rear to remove control
knobs).
Installation
1. Install HVAC unit, secure with screws (x8), fit control
knobs (x3) and connect multiplugs (x2).
2. Refit centre stack assembly (see Workshop Manual
procedure 15.01.CB Centre Stack Assembly - Remove
for Access & Refit).
Workshop Manual
Climate Subsystem (12.04)
Climate Control (12.00)
Code
15.01.CM
Code
15.01.CN
Code
15.01.CP
12-4-1