Aston Martin V8 Vantage Workshop Manual page 180

2. Press 'Mode' until pressure / temperature units are
displayed.
3. Press 'Tyre' to enter 'Units Selection' mode.
4. Use 'Tyre' or 'Mode' to scroll through four combinations
of pressure / temperature units.
5. Press 'Set' to save the selected combination of units.
6. Press the 'Set' button again to revert to normal mode.
Level 2 Programming
Slope
Sets rate of pressure change for tyres in use. This parameter
is set at manufacture and is specific only to the
recommended tyres for DB9.
1. Press 'Set' for 5 seconds to enter level 2 programming.
2. Press 'Tyre' until the desired vehicle axle is displayed.
3. Press 'Mode' to display the current SLOPE entry (DB9 is
set at?)
4. If required, use 'Tyre' to increase or 'Mode' to decrease
current value.
5. Press 'Set' to save the final value.
6. Press 'Set' again to return to normal mode.
Transmitter Learn Mode
This mode is used to add or delete transmitters from the
system memory. It is vital that transmitter signals are
correctly recognised to avoid system reaction to other
transmitters (e.g. from passing vehicles with similar sensors).
1. Remove a Redundant Transmitter
1.1 Press 'Set' for 5 seconds to enter level 2
programming.
1.2 Press 'Mode' to select 'Transmitter Learn' mode.
1.3 Press 'Tyre' to display possible tyre positions (filled
rectangles represent currently programmed
transmitters).
1.4 Press 'Tyre' to scroll to the desired position.
1.5 To delete a transmitter, press the 'Mode' once.
1.6 If required, scroll to other positions using 'Tyre' and,
if required, delete any other transmitters using
'Mode' button.
October 2005
2. Add new Transmitters.
2.1 Press 'Set' for 5 seconds to enter level 2
programming.
2.2 Press 'Mode' to select 'Transmitter Learn' mode.
2.3 Press 'Tyre' to display possible tyre positions (filled
rectangles represent currently programmed
transmitters).
2.4 Press 'Tyre' to scroll to the desired position. The
chosen road wheel icon will flash.
2.5 Program a new transmitter by either:
2.6 Vigorously shaking the transmitter (bounce the road
wheel on the ground) to promote a transmission.
2.7 Inflate or deflate the tyre by more than 3 psi (0.2
bar).
The unit will 'beep' when new transmitter is recognised.
2.8 Press 'Tyre' to scroll to the next position. Repeat
steps 4 and 5 as required to programme additional
transmitters.
36-5-052
2.9 Press 'Set' to save the new transmitter data and to
exit 'learn' mode. If no error is found, the system will
return to 'normal' mode.
Level 3 Programming
Low Pressure Alert
1. Press 'Set' for 10 seconds to enter level 3 programming.
2. Press 'Tyre' button to scroll to the desired axle.
3. Press 'Mode' to view the current low pressure alert
value.
4. Press 'Tyre' to increase the current value or press
'Mode' to the decrease current value.
5. Press 'Set' to save when the desired value is reached.
6. Repeat steps 2 to 5 until the Low Pressure Alert Level
has been set for all road wheels.
7. Press 'Set' button to exit this mode.
8. Press the 'Set' button again to return to normal mode.
Workshop Manual
Road Wheels and Tyres (04.04)
Suspension (04.00)
36-5-051
4-5-11