Bds To Bulkhead Dirty Feed Harness-Renew; Engine Earth Strap-Renew; Hood Earth Strap-Renew - Aston Martin V8 Vantage Workshop Manual

BDS to Bulkhead Dirty Feed Harness-
Renew
Repair Operation Time (ROT)
Item
BDS to Bulkhead Dirty Feed Harness-
Renew
Removal
1. Remove RH seat (see Workshop Manual procedure
01.10.AA Seat Assembly - Front - RH - Remove for
Access and Refit).
2. Disconnect vehicle battery.
3. Remove screws (x4), retaining brackets securing front
floor carpet, remove brackets (x2).
4. Release RH rear floor carpet from fasteners (x4), remove
carpet.
5. Remove nuts (x2) and screws (x2) securing RH rear heel
board to body and support rail. Remove heel board.
6. Remove nuts (x3) and screws (x6) securing CEM cover
plate to body, remove cover plate.
7. Release cover, remove nut securing battery dirty feed
cable to bulkhead stud.
8. Release battery dirty feed cable clips (x9) from body.
9. Remove nut securing battery dirty feed cable to BDS,
release cable from BDS.
10. Remove battery dirty feed cable from vehicle.
Installation
1. Install battery dirty feed cable in vehicle.
2. Connect battery dirty feed cable to BDS, install and
torque tighten nut.
3. Secure battery dirty feed cable to body with clips (x9).
4. Connect battery dirty feed cable to bulkhead stud,
install and torque tighten nut. Install terminal cover.
5. Install CEM cover plate, Install and torque tighten nuts
(x3) and screws (x6).
6. Install RH rear heel board, install and torque tighten nuts
(x2) and screws (x2).
7. Install RH rear floor carpet and secure with fasteners
(x4).
8. Install front floor carpet retaining brackets (x2), install
and tighten screws (x4)
9. Install RH seat (see Workshop Manual procedure
01.10.AA Seat Assembly - Front - RH - Remove for
Access and Refit).
10. Connect vehicle battery.

Engine Earth Strap-Renew

Repair Operation Time (ROT)
Item
Engine Earth Strap-Renew
Removal
1. Raise vehicle on ramp.
October 2005
2. Remove rear undertray (see Workshop Manual
procedure 01.02.PB Undertray - Rear - Renew).
3. Remove bolt securing engine earth strap to RH transaxle
mounting bracket.
4. Remove nut securing engine earth strap to body,
Code
remove earth strap.
14.01.EK
Installation
1. Clean earth points on transaxle mounting bracket and
body.
2. Position engine earth strap, install and torque tighten
nut and bolt.
3. Install rear undertray (see Workshop Manual procedure
01.02.PB Undertray - Rear - Renew).
4. Lower vehicle on ramp.

Hood Earth Strap-Renew

Repair Operation Time (ROT)
Item
Hood Earth Strap-Renew
Removal
1. Remove cap nuts (x2), hood and body terminals.
2. Remove nuts (x2), securing earth strap to hood and
body terminals.
3. Release clips (x2), earth strap to body, remove earth
strap.
Installation
1. Clean earth points on hood and body.
2. Install new clips (x2) to earth strap.
3. Install earth strap, install and torque tighten nuts (x2).
4. Secure clips (x2), earth strap to body.
5. Install and tighten cap nuts (x2).
Code
14.01.EP
Workshop Manual
Battery System (14.01)
Power Supply (14.00)
Code
14.01.EQ
14-1-7